Installation Manual - 300 Series Consoles & 310 Show Controller
Welcome
Warning
Thank you for buying Strand Lighting control equipment. We hope that you
will find that your lighting needs are met by your new system and that you
will enjoy exploring the new facilities that your new system offers. You are
provided with essential information to help you install and operate your sys-
tem. Please look through all the documents and keep them safely for future
use. If you have any difficulties, please do not hesitate to contact Strand
Lighting, or any authorised Strand service centre for advice.
This equipment is designed to operate from the mains electricity supply
and contains voltages which, if touched, may cause death or injury. It should
only be operated in accordance with the instructions provided and for the
purpose of a lighting control system.
Avoid spilling liquid on the equipment. If this should happen, switch the equip-
ment off immediately. To reduce the risk of fire or electric shock, do not expose
the equipment to rain or moisture.
For indoor use only.
This equipment is designed and manufactured to comply with international safety
standards IEC950, UL1950, CS950 and is intended for use as part of a lighting
control system. It must not be used for other purposes where there is a risk of
safety to persons. The equipment contains power voltages, socket outlets shall
be installed near to the equipment and be easily accessible.
• Working Voltage/Current 100-120 (2A) 220-240 (1A)
• Frequency 50/60 Hz
• Max Ambient Temp 35
o
C
• Do not restrict ventilation
This manual describes the installation procedures for the following Strand
Lighting 300 Series consoles.
• 24/48 Manual/Memory
• 48/96 Manual/Memory
• Memory 125
• Memory 250
• Memory 400
• Memory 600
• 120 Submasters
• 310 Show Controller
Page 1
Document No: 40/B973
Date: March 2000
To Next Page
Need help?
General
