COOLDEK CLASSIC
COOLDEK CGI
CONTACT
1300 165 165
www.stratco.com.au
All brands and logos/images accompanied by ® or ™ are
trade marks of Stratco (Australia) Pty Limited.
© Copyright May 2011
WALKING ON COOLDEK
MAINTENANCE
When walking on Cooldek roong, it is recommended you walk over the
support beam to avoid damage. Wear at, rubber soled shoes and walk
at footed in the sheet pans for Classic, and with your weight spread over
as many crests as possible for CGI. For carport and verandah applications,
away from supports, crawl boards should be used to avoid damage during
installation and maintenance.
The performance of Cooldek over time depends on its correct application
and maintenance. Maintenance should be performed as often as is required
to remove dirt, salt and pollutants.
Where used in severely corrosive environments, cleaning should be
performed more often.
It is important that screws have the same life expectancy as the cladding
you have specied.
Packs of Cooldek should always be kept dry and stored above ground level
while on site. If the sheets have become wet, they should be separated,
wiped and placed in the open to dry.
Refer to Stratco “Selection, Use and Maintenance” brochure, for more
detailed information about the correct use and maintenance of this product.
To Previous Page
Loading...