4.1 Left/right installation setting
WARNING：This step must be completed prior to setting travel limits (4.2) if utilizing a
lift sided installation.
If utilizing the standard right sided installation this step can be ignored.
Press ‘SET’ button and hold on until LED displays figure ‘5’, press ‘UP’ or ‘DOWN’ button to choose ‘1’ left
installation or ‘0’ right installation. Press ‘SET’ button to confirm the setting. The default setting is right hand
installation.
“0” means right installation Press ‘UP’ button
Press ‘SET’ button Display from 1 to 5
“1” means left installation Press ‘DOWN’ button
Turn into “1” (left installation)
Turn into “0” (right installation) Press ‘SET’ button to confirm setting
Please follow all setup steps from start to finish on
initial install to ensure correct functionality of your new
garage door opener. Failure to do so may result in
operational issues.
10
To Next Page
Loading...
