STRATOS FU-230 User Manual (English)

Other manuals for STRATOS FU-230

Questions and Answers:

M
Margaret QuinnJul 29, 2025
Why does my STRATOS FU-230 Lathe vibrate?
- J
  Jennifer TaylorJul 29, 2025
  If your STRATOS Lathe vibrates, several factors could be at play. It might be due to an unbalanced work piece – try compensating for this or reducing the speed. Ensure the work piece is securely clamped; improving the clamping length or diameter, supporting the tailstock end, or using a steady rest can help. A blunt cutting edge on the tool could also cause vibration, so sharpen or replace it. High cutting pressure can also be a culprit; reduce the depth of cut or feed. Check that the work piece is clamped centrically and that the speed isn't too high. Tighten any loose pulleys. If the machine is on an uneven floor, use an adjustable leveler to compensate. Finally, ensure the tool rest, tailstock, and headstock are securely locked, tightening the self-locking nut underneath if necessary.
J
Joshua WhiteAug 3, 2025
What to do if my STRATOS Lathe does not turn on?
- K
  katherineharveyAug 3, 2025
  If your STRATOS Lathe does not turn on, there are several potential causes. First, check the mains fuse to ensure there is power. If the power supply is not the issue, the motor, switch, or cable may be faulty, in which case you should contact an electrician. Another common reason is that the cover is not properly closed; make sure to close and secure it. Also, check if the spindle lock or 24-position indexing is locked and release it if necessary. Finally, ensure that the main switch is set to the 'I' position.
C
Christine RobertsonAug 9, 2025
Why does my STRATOS FU-230 keep switching off?
- A
  Alex MillerAug 9, 2025
  If your STRATOS Lathe switches off, the issue might stem from a lack of mains voltage, so check the mains fuse. Alternatively, the frequency converter might have switched off. In this case, wait about 10 minutes before turning it on again.
R
randy25Aug 16, 2025
What to do if my STRATOS Lathe judders?
- Z
  zodonnellAug 16, 2025
  If your STRATOS Lathe judders, it could be due to a feed that is too large or a work piece surface that is too rough; try reducing the feed. Another cause might be a blunt wood turning tool, so resharpen it. Misaligned centers can also cause juddering, so adjust the headstock. Lastly, if the wood turning tool springs, move the tool rest closer to the work piece.

STRATOS FU-230 Specifications

General

Brand	STRATOS
Model	FU-230
Category	Lathe
Language	English

STRATOS FU-230 Original Operating Manual

Table of Contents

Other manuals for STRATOS FU-230

Questions and Answers:

STRATOS FU-230 Specifications