Stratus SAE-UT9000 - User Manual

Questions and Answers

M
Michelle GibsonAug 11, 2025
What to do if the motor runs but Stratus Lifting Systems will not raise?
- G
  Glenn FarleyAug 11, 2025
  If the motor runs but the Stratus Lifting Systems platforms will not raise, it could be due to several reasons. First, check the wire connection, because the motor might be running in reverse. Also, the overflow or cushion valve might be loose or jammed, requiring cleaning or adjustment. The gear pump could be damaged and in need of replacement. Ensure that the oil level is adequate by adding oil if it's too low. Finally, inspect the oil hose to ensure it is tightened and has not become loose or dropped off.
K
Kathleen JohnsonAug 17, 2025
Why are Stratus Lifting Systems platforms going down slowly after being raised?
- K
  Keith ZavalaAug 17, 2025
  If your Stratus Lifting Systems platforms are going down slowly after being raised, there are several potential causes. Start by checking the oil hose for leaks and replace it if necessary. Also, ensure the oil cylinder is properly tightened; if not, replace the seal. Additionally, inspect the single valve, overflow valve, and electrical unloading valve for leaks, and clean or replace them as needed.
J
jennifer34Aug 23, 2025
Why is my Stratus Lifting Systems raising too slow?
- D
  daniel57Aug 23, 2025
  If your Stratus Lifting Systems is raising too slowly, several factors could be the cause. The oil filter might be jammed, so try cleaning or replacing it. Make sure the oil level is sufficient by adding oil if it's too low. Check that the overflow valve is correctly adjusted. If the hydraulic oil is too hot (above 45°), consider changing it. Lastly, inspect the cylinder seal for abrasion and replace it if necessary.
C
Carlos BradyAug 28, 2025
How to troubleshoot a Stratus Lifting Systems when the motor does not run?
- R
  rojasalyssaAug 29, 2025
  If the motor of your Stratus Lifting Systems does not run and will not raise, begin by checking the wire connections to ensure they are secure. If the connections are good, the motor might be burnt out and need replacement. Also, inspect the limit switch for damage or loose wire connections, and connect, adjust, or replace it as needed to ensure smooth movement.
N
Nicholas GeorgeSep 3, 2025
What to do if Stratus Lifting Systems is lowering too slow?
- T
  taylorpatelSep 3, 2025
  If your Stratus Lifting Systems is lowering too slowly, it could be due to a few reasons. The throttle valve might be jammed, so try cleaning or replacing it. Also, if the hydraulic oil is dirty, changing it could resolve the issue. Check the anti-surge valve for any jamming and clean it if necessary. Lastly, inspect the oil hose for blockages and replace it if needed.