Why is no water coming out of my Strauss water T6?
If water isn't dispensing from your Strauss water Water Dispenser, first, ensure the dispenser is properly connected to a working electrical outlet. Check the main water outlet to be sure it is open. If there's a water outage, check other outlets in your home. As a last resort, try disconnecting and reconnecting the dispenser from the power source.
What to do if my Strauss water Water Dispenser is leaking?
If you notice leakage from your Strauss water Water Dispenser, the first thing to check is whether the drop collector is full and needs emptying. If the leakage persists, disconnect the device from the electrical source, close the water inlet and call for a service technician.
Why is the hot water not hot enough on my Strauss water T6?
If the water from your Strauss water Water Dispenser isn't hot enough when pressing the HOT button, make sure the heat switch on the back of the device is in the ON position. If it is already on, you may have over-consumed hot water; wait approximately 3 minutes and try again.
What to do if cold water doesn't come out of Strauss water Water Dispenser?
If no cold water is coming out of your Strauss water Water Dispenser, it might be due to over-consumption of cold water. Wait approximately 15 minutes and try again. Alternatively, try resetting the UV system by disconnecting and reconnecting the UV lamp.
Why is no hot water coming out of my Strauss water T6 Water Dispenser?
If hot water isn't dispensing at all from your Strauss water Water Dispenser, the device might be in 'Energy Saving' or 'Child Safety' mode. Wait until 'Heating Done' is indicated.
Why does my Strauss water T6 have an irregular flavor?
If you notice an irregular flavor from your Strauss water Water Dispenser, and the device is new, execute an automatic flush. If the device hasn't been used for a long period, replace the filter and then execute an automatic flush.
Dispense continuous cold water by holding the cold water button.
Dispense a preset quantity of cold water using the cup button.
Dispense 1 litre of cold water by pressing the cold and cup buttons.
Dispense hot water by pressing the hot and cup buttons simultaneously.
Dispense a preset quantity of hot water using the hot water button.
Heat water to near boiling temperature using the extra hot button.
Dispense mixed cold and hot water at a set temperature and quantity.
Allows adjustment of the desired cold water temperature within a range.
Sets the specific quantity of cold water dispensed with the cup button.
Allows adjustment of the desired mix water temperature within a range.
Troubleshooting steps when no water or incorrect temperature water is dispensed.
General| Brand | Strauss water |
|---|---|
| Model | T6 |
| Category | Water Dispenser |
| Language | English |
To Next Page
