With the case now fully assembled, take one final look to make sure all the
universal bracket screws have been correctly tightened, all the cables have
been connected and that there is nothing loose that could make contact
with the fans.
Final Inspection and Replacing the Side Panels
The side panels are replaced by resting the upper edge on the top frame
of the case, then pushing the lower edge onto the bottom frame until it sits
flush with the edge of the case.
When resting the upper edge of the side panel, make sure the rubber
catch is correctly positioned on the frame otherwise it will be difficult to
push the lower edge onto the bottom frame.
15
Side Dust Net
The case also includes a side net which can be fitted depending on the
airflow and cooling strategy you have implemented. We recommend only
using the net if air is being drawn though it from the side panel as installing it
will impede airflow and is not required or useful when air is being expelled
from the case.
The net is magnetic and will stick to the vertical frame of the case and
should be attached centrally between the upper and lower tracks. Fitting
the side panel will further secure the net to the case.
Side Panel
EVA Pad
Rubber Catch
Frame
Magnetic Strip
Vertical Frame
To Next Page
Loading...