StreamLight SYCLONE - User Manual

To Next Page

Operating

Instructions

OPERATING INSTRUCTIONS FOR RECHARGEABLE STREAMLIGHT SYCLONE

Safety

A. Use only Streamlight battery #13057. Dispose of worn out or damaged batteries

properly. Do not attempt to incinerate the battery as it may explode in a fire and never

allow it to short circuit.

B. A small leakage of liquid from the battery cells may occur under extreme usage or tempera-

ture. This does not necessarily indicate a failure. However, if the outer case seal is broken

and liquid gets on your skin: Wash the affected area promptly with soap and water.

Neutralize with a mild acid, such as lemon juice or vinegar. If battery liquid gets into your

eyes flush them with clear water for a minimum of ten (10) minutes and seek immediate

medical attention. (Medical note: The liquid is 25%-35% solution of potassium hydroxide.)

C. It is important to keep the two (2) holes on either side of the flashlight head/body and

pivot area/body clean and clear of debris.

OPERATION

The Syclone is designed for multiple applications, waterproof to 100 feet and quickly

becomes a hands-free light with its snap-on helmet attachment or optional elastic head strap.

The 360 degrees rotating clip fastens to belt, harness or pocket. Attachment points on the tilt-

ing head and clip accept hooks or lanyards. It features two (2) separate bulbs selectable by

swinging the switch to the right or left and adjustable focus. The light accepts either the

rechargeable nickel-metal hydride battery pack or, if needed, the 4 "AA" alkaline battery clip,

P/N 13056.

GENERAL

The on-off switch is located on the back of the tilting head. The center position is “OFF”. Flip

the switch to the left for the LED backup light; to the right for the high intensity Krypton beam.

CHARGING

The charge is designed to hold the Syclone in virtually any position and charge without disas-

sembly. Two (2) self-tapping #8 x 2" screws are included to mount the charger; use 1/8"

holes. The charger can use four (4) interchangeable power cords; P/N: 22051 12V DC

cord with cigarette lighter plug (DC 1); P/N: 22050 12V DC Direct Wire cord (DC 2); P/N

22311 120V AC cord; P/N: 21725 230V AC cord.

Fully charge your Syclone before the first use. Several charge/discharge cycles may be neces-

sary to achieve full battery capacity. To charge the Syclone, turn it off and insert it into the

charger tailcap down until it snaps into place. The LED should light, indicating that the charge

current is flowing. A full charge is achieved in ten (10) hours. Normally, the Syclone can be

left on charge continuously. However, if the surrounding temperature is below 10 degrees F,

continuous charging is not recommended. Remove the Syclone from the charger by depressing

the pushbutton on the side of the charger holder. A fully charged Syclone should operate a

Krypton lamp for two (2) hours and an LED for over twenty four (24) hours.

VEHICLE INSTALLATION

WARNING: A shorted auto battery can easily start a fire. Use the proper insulated connectors

and be sure that your installation is fused with a 1 amp slow blow fuse. If you are not skilled

in this type of work have a skilled professional install the Syclone charger.

SYCLONE

Need help?

Do you have a question about the StreamLight SYCLONE and is the answer not in the manual?

Summary

SYCLONE Operating Instructions

Safety

Crucial safety guidelines for battery handling, leakage, and debris.

Operation

Details on flashlight applications, hands-free use, and attachment options.

General

Explains the on-off switch operation for different light modes.

Charging

Instructions for charging the Syclone, including power cords and charging time.

Vehicle Installation

Warning and guidance for installing the charger in a vehicle.

SYCLONE Operating Instructions Continued

Care and Use of Nickel-Metal Hydride Batteries

Proper care and usage advice for rechargeable batteries to prevent damage.

Bulb Replacement

Step-by-step guide for replacing the primary and backup bulbs.

Waterproofness

Information on maintaining waterproof integrity with O-rings.

Cyclone Hands-Free Mounting System

Details on the included mounting clip for hands-free use.

Attaching the Mounting Clip with the Adhesive Pad

Instructions for securely attaching the mounting clip using the adhesive pad.

Replacement Parts

Part Identification and Diagram

Lists all replacement parts with part numbers, descriptions, and a visual diagram.

Accessory Cords and Charger

Details various power cords and the charger/holder available for the Syclone.

Warranty Information

Warranty Registration

Instructions on how to register the product warranty and required proof of purchase.

Product Use and Recycling

Specifies intended use and provides guidance on battery disposal and recycling.

Money Back Guarantee

Details the satisfaction guarantee and refund policy for the product.

Limited Lifetime Warranty

Explains the terms and conditions of the limited lifetime warranty for the flashlight.

Limitations on Warranty and Service Coverage

Outlines conditions under which the warranty is invalid or limited.

Battery Stick and Charger Holder Warranty

Specifies the warranty period for the battery stick and charger holder.

The Streamlight Syclone is a rechargeable, multi-application flashlight designed for hands-free use and durability. It is waterproof to 100 feet and can be used with various mounting options.

Function Description

The Syclone serves as a portable light source with two selectable bulbs: an LED backup light and a high-intensity Krypton beam. The on-off switch is located on the back of the tilting head, with a center "OFF" position. Flipping the switch to the left activates the LED, while flipping it to the right activates the Krypton beam. The flashlight features adjustable focus, allowing users to modify the light pattern.

For hands-free operation, the Syclone can be attached to helmets using a snap-on helmet attachment or an optional elastic head strap (P/N 13070). A 360-degree rotating clip allows it to be fastened to a belt, harness, or pocket. Attachment points on the tilting head and clip accept hooks or lanyards for versatile carrying.

The device is powered by a rechargeable nickel-metal hydride battery pack (P/N 13057). Alternatively, it can use a 4 "AA" alkaline battery clip (P/N 13056) if needed (batteries not included with the clip).

Important Technical Specifications

Waterproofness: Up to 100 feet.
Battery: Rechargeable nickel-metal hydride battery pack (P/N 13057) or 4 "AA" alkaline battery clip (P/N 13056).
Charging Time: Approximately 10 hours for a full charge.
Run Time:
- Krypton lamp: Approximately 2 hours.
- LED: Over 24 hours.
Bulb Life Expectancy (Krypton): 25 hours.
Charging Current: 100 milliamperes from a vehicle battery.
Charger Power Cords:
- P/N 22051: 12V DC cord with cigarette lighter plug (DC 1).
- P/N 22050: 12V DC Direct Wire cord (DC 2).
- P/N 22311: 120V AC cord.
- P/N 21725: 230V AC cord.
Mounting Clip Adhesive: Super durable, very high bond acrylic glue.
Fuse Requirement (Vehicle Installation): 1 amp slow blow fuse.

Usage Features

Hands-Free Operation: The Syclone comes with a unique mounting clip (P/N 13050, P/N 13150, or P/N 13650) that can be permanently attached to helmets, bulkheads, dashboards, and other structures. This clip can be secured using #8 threaded fasteners or the included VHB adhesive pad.
Mounting Clip Attachment (Adhesive Pad):
1. Determine the desired location and orientation on the helmet.
2. Wearing gloves, heat the mounting clip with a heat gun or by placing it in boiling water for 30 seconds until pliable.
3. Press the clip against the surface until it conforms to the shape and cools.
4. Clean mounting surfaces with alcohol and let them dry.
5. Remove backing from one side of the adhesive pad and affix it to the mounting clip.
6. Remove the remaining backing, align the clip with the surface, and press firmly into place with the hooks facing up.
7. Allow 24 hours for the mounting to cure before use.
Adjustable Focus: The facecap can be rotated to adjust the focus pattern of the light.
Bulb Selection: A switch allows users to easily toggle between the LED backup light and the high-intensity Krypton beam.
Charging: The Syclone can be charged in virtually any position without disassembly. To charge, turn the flashlight off and insert it tailcap down into the charger until it snaps into place. An LED on the charger indicates current flow. Continuous charging is generally acceptable, but not recommended if the surrounding temperature is below 10 degrees F. To remove the Syclone, depress the pushbutton on the side of the charger holder.
Vehicle Installation: For permanent vehicle installation, use the DC 2 direct wire cord (P/N 22050). Connect the striped positive lead to a fused 12-volt power source (with a 1 amp slow blow fuse) and the unstriped negative lead to a convenient chassis ground. Professional installation is recommended if unfamiliar with this type of work.

Maintenance Features

Battery Care: Use only Streamlight battery #13057. Dispose of worn or damaged batteries properly; do not incinerate or short circuit. Avoid deep discharging the nickel-metal hydride battery repeatedly, as this can shorten lamp and battery life, and potentially cause cell damage or rupture due to pressure buildup. Leaving the light running until the lamp becomes dim can reduce the useful life of the rechargeable battery system.
Cleaning: Keep the two holes on either side of the flashlight head/body and pivot area/body clean and clear of debris.
Waterproofness Maintenance: Lubricate the "O" Rings in the facecap and tailcap with silicone grease and keep the tailcap tight to maintain waterproofness.
Bulb Replacement:
1. Ensure the flashlight is in the "Off" position.
2. Unscrew the facecap/lens assembly and remove the reflector and focus spring.
3. Pull the old bulb straight out.
4. Fit the primary (central) bulb socket with a Krypton bulb (P/N 13048). Align the pins at the base of the new bulb with the holes in the socket and slide it in until it seats. Do not force.
5. The secondary (off-center) bulb socket fits either a Krypton bulb or an LED (P/N 13043). Both bulbs are keyed to fit only one way.
6. To reassemble, place the focus spring around the primary bulb socket, ensuring it's fully seated on the ledge.
7. Grasp the reflector by the edges, aligning its holes with the two bulbs and its keys with the slots on the interior of the flashlight head.
8. Ensure the "O" Ring on the outside of the flashlight head is in place and lubricated with silicone grease.
9. Replace the facecap over the head, being careful not to crossthread. Rotate the facecap to adjust the focus pattern.
- Caution: Never touch a hot bulb and wear eye protection during replacement. Avoid handling bulbs with bare fingers.
Warranty: Streamlight offers a Limited Lifetime Warranty on the Syclone (excluding lamp, battery, and charger holder), covering the case and internal components from the date of purchase. In jurisdictions with specific limitations, a 10-Year Limited Warranty applies. The battery stick and charger holder are warranted for one year. Warranty is void if there is tampering, alteration, abuse, misuse, or failure to follow proper care and maintenance procedures. Repairs must be performed by Streamlight or designated service facilities. The warranty is limited to the original user-purchaser.
Battery Disposal: The rechargeable battery is recyclable. Check with local solid waste officials for proper disposal, as it may be illegal to dispose of it in municipal solid waste streams in some areas.