EN
- Lead or in the immediate vicinity of pipes or containers, flammable or explosive substances.
2. Place the heater on a firm, level ground.
3. Do not insert objects through the ventilation slots of the device.
4. The heater is not designed for use in bathrooms, washrooms or other damp areas. Set the heater on so
that the unit in water tank (bath, ...) or the like may fall.
5. WARNING: The free air outlet must not be affected. Therefore, the upper and grilles of the unit may
not quite yet be partially covered for safety reasons.
6. After use, turn the power zurerst, then unplug the power cord..
7. Make sure that the power cord does not touch the radiator. Place the unit directly under a wall outlet.
8. Check before you use the appliance if the mains voltage with which you want to operate the device
matches the specified on the nameplate of the device voltage!
9. The convector is used solely for heating or tempering of rooms. The device is intended for normal
household use and similar purposes.
10. Never operate the appliance unattended.
11. The noise after turning on / off of the unit is normal.
12. The device may only be opened and repaired by a specialist.
13. Never pull on the cord to move the device! Make sure that does not happen to be the connecting cable
gets stuck somewhere and doing this for the case of the device could!
14. Keep a safe distance from 1 m around the device.
15. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be
given where children and vulnerable people are present.
WARNING:
- The machine must not be covered, since it can be overheated or otherwise fire hazard.
- Children or persons who lack knowledge or experience with the device, or who are restricted in their
physical, sensory or mental disabilities may not use the device without supervision or instruction by a person
responsible for their safety.
- The unit should be kept away from children.
- If the supply cord is damaged it must be replaced by the manufacturer or its service agent or a qualified
person in order to avoid a hazard.
CARE AND MAINTENANCE:
Disconnect the device from the mains before cleaning! Wait, if necessary, until it has cooled to normal
temperature. Clean the vents with a soft brush.
The rest of the case is to be wiped off with a soft, dry cloth. If heavily soiled, use a slightly damp cloth. Do
not use abrasive cleaners or solution center!
For longer periods store the device protected from dirt and dust, and in a dry place at.
To Next Page
Loading...