spring keeper and reinstall the clutch spring into
the hole in the base. Adjustment of the clutch
more than 10 degrees to 20 degrees should
normally not be necessary. With only spring
pressure (do not forcibly tighten the clutch mech-
anism) the spring lug on the spring keeper
should come to rest at approximately the 2:30
o’clock position.(See FIG. 7)
Go to Dutton-Lainson website:
http://www.dutton-lainson.com/ts.php for
trouble shooting manual, select winch model
number and click on symptom “Motor runs
but winch fails to pull cable” for complete
diagnoses and corrective action.
5. Check the pulley block and hook assembly
(MODELS SA7000AC AND SA12000AC) to be
sure that the pulley rotates freely on the bronze
p
ulley spacer. Occasional greasing of these two
items is recommended.
FIG. 6
FIG. 7
O
-Ring Illustration
Clutch Spring Illustration
E
N
G
L
I
S
H
5
Clutch Spring
Keeper
Spring Lug
Clutch Spring
If you are having any problems with this electric winch, go to Dutton-Lainson website:
http://www.dutton-lainson.com/ts.php to view trouble shooting manual. This manual
will help diagnose most problems with this winch.
To Next Page
Loading...