A pattern-sequenced tremolo with user definable patterns. Up to eight
beats can be sequenced, with one to sixteen trem cycles per beat. The
unique and rhythmic effects can be sync’ed with a single press of the
TAP footswitch.
PARAMETERS:
WAVESHAPE:
Selects the waveform shape of the tremolo LFO.
Triangle
Square
Rectangle
Pulse
Ramp
Saw
Sine
BEAT 1: Sets the number of subdivisions for each beat.
Additionally, when set to full, the signal is present with
no tremolo applied during that beat. When set to zero,
no signal is present for that beat.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
FULL
ZERO
BEAT 2-8: Has the same parameters as beat 1 but includes a ‘--
--‘ option to ignore the beat and all subsequent beats,
which signifies the end of the sequence.
----
[ ... additional parameters identical to beat 1 ]
PAN: Determines the phase offset between the Left and
Right LFO signals. Listen to the effect it has on the
stereo image as you adjust the parameter. NOTE: Only
applies when using the unit in a stereo configuration.
Off
On
Continued on Next Page
To Next Page
Loading...
