STS/Mutoh XPD 724 Printer Guidelines www.stsinks.com
3. Before installing, remove any free ink from the end of each 500mL white cartridge with
a paper towel.
4. Make sure the Heat Platen is free from residue or ink (the metal surface that the substrate
prints on, and that the media guards are also clean, as well as underneath them)
5. Perform a nozzle check before printing to check nozzle quality, followed by a head
cleaning if needed (short clean) and repeat the process until the nozzle pattern is drop-
out free.
• Every 2-3 Months
Use your MSM dashboard to Long Store your printer and follow the instructions provided on the screen,
this will ensure your lines are kept in working condition and help the longevity of your print head.
• Best Practice Habits
1. Always print with the front cover in the down position.
2. Protect the printer from electrical disruptions and power outages with a 500VA UPS
surge protector.
3. Do not use inks that are expired.
4. Do not turn o the printer.
Do not lift or touch the media when the printer is in operation! WARNING
STS Inks will not warranty any head damage due to operator error.
Please always follow best practice guidelines.
• What to do if the print head strikes the PET lm
Immediately stop printing and start the head cleaning process, Purchase Nozzle buster solution and
ll capping station with nozzle buster solution and turn the printer o with the head sitting in locked
position for 6+ hours (When wet capping printer must to be o).
Note: The next day shake the white cartridges as usual, then perform a nozzle check the following day.
Also, never park the head directly on the PET lm.
Note: Sustained head cleanings can put too much pressure on the print head and may cause the print
head to delaminate and fail prematurely. In the event the nozzle does not recover, print in high quality
(720x1080) or 2x white as the Flexi setup shows below.
To Next Page
Loading...