STS/Mutoh XPD 724 Printer Guidelineswww.stsinks.com
5. Short press the operation key on the operation panel.
* The carriage moves to the maintenance position inside the
front cover.
7. Wipe the clean wiper with a cleaning stick.
* Wipe the left side durface of cleaning wiper going back and
forth.
IMPORTANT - When cleaning the cleaning wiper, please note the followings.
• Use a cleaning stick in dry condition. If moisten with water or solution, it can cause
damage to the printhead.
• Do not reuse a cleaning stick. Dusts can adhere causing damage to the print head.
• Standard cleaning time should be within 5 minutes. If it takes longer, the stick can dry
causing damage to the print head.
8. Wipe the right side surface of cleaning wiper going back
and forth.
9. Wipe the right side surface of the base of cleaning wiper
going back and forth.
11. Short press the operation key on the operation panel.
* The carriage moves to the original position inside the front
cover.
6. Open the front cover.
10. Close the front cover.
To Next Page
Loading...