STS/Mutoh XPD 724 Printer Guidelines www.stsinks.com
• Inside Cleaning
Cleaning period:
• Monthly.
Steps:
3. Brush o dusts on the pressure arm with a soft brush.
IMPORTANT
* Do not blow o dusts inside the product with a gas duster.
It may cause abnormal noise.
4. Using a soft cloth that is soaked in water and squeezed
tightly, wipe dirt on the platen media guide.
6. Close the front cover.
1. Check the power is OFF.
2. Open the front cover.
IMPORTANT
Inmediately after turning OFF the power, the temperature of the heater on this product
is very high.
Touch the platen or media guide and if it is too hot, wait for a while before starting
cleaning.
5. Using a soft cloth that is soaked in water and squeezed
tightly, wipe dirt on the silver part of grid roller.
To Next Page
Loading...