E-7
AUX IN OPERATION
The SB2001 provides an auxiliary audio signal input jack for connecting external audio
devices like MP3 players, CD players and iPods (except iPod shuffle 3rd generation) for
listening to your external source through the speaker of this system.
1. You need an audio cable (not included) with one 3.5 mm stereo plug on each end of the
cable.
2. Plug one end of the cable into the AUX IN JACK (#8) located on the right hand side of the
unit and the other end of the cable into the Line-out Jack or Headphone Jack of your
external audio device.
3. Turn on the external audio device.
4. Turn on SB2001 and it will switch to AUX mode automatically.
5. The volume level can now be controlled through the volume control of your radio. Operate
all other functions on the auxiliary device as usual.
Notes:
(1) If you connected the Line-out Jack on your external device then you only need to adjust
the volume control of this system. If you connected the Headphone Jack of your external
device then you may need to adjust both the volume control of your external device and
the volume control of this system to find the most desirable volume setting.
(2) Remove the audio cable from AUX IN JACK (#8) when you finish listening. Don't forget to
switch off the power on your external device as well.
CARE AND MAINTENANCE
Clean the radio with a soft damp cloth and let all parts dry completely after cleaning.
Do not use any aggressive cleaners, brushes with nylon bristles, sharp or metallic
cleaning utensils, knives, hard scrapers and the like. They could damage the surfaces of
the radio.
Do not immerse the radio in water and do not let water get into the housing of the radio.
Unplug the power adaptor and clean the radio before storage.
Always store the radio in a dry and clean place.
SPECIFICATION
AC Power: AC 120V ~ 60Hz 4W
Battery: 4 x 1.5V C size batteries (not included)
Frequency Range: FM 88 – 108 MHz
AM 525 – 1710 KHz
TROUBLESHOOTING GUIDE
To Next Page
Loading...
Need help?
General