Studebaker SB5050 - Page 14

E-13
7. While playing, press the PLAY/PAUSE BUTTON (#18) to pause, the play icon will
flash on the LED DISPLAY (#1). Press PLAY/PAUSE BUTTON (#18) again to resume
playing.
8. Tap VOLUME + / VOLUME - (#25) to the desired volume level.
9. Press CD STOP

BUTTON (#21) to stop playing.
10. Tap the POWER BUTTON (#12) to turn off the unit.
Notes:
• If skipping occurs during CD play, try turning the volume down.
• Do not open the CD DOOR when a CD is playing.
REPEAT MODE
Repeat 1:
Tap the REPEAT BUTTON (#16), the repeat icon “REP 1” will light on the LED DISPLAY (#1).
The current track will be repeated until it is interrupted.
Repeat All:
Tap the REPEAT BUTTON (#16) again; the repeat icon “REP ALL” will light on the LED
DISPLAY (#1). The whole disc will be played repeatedly.
To Cancel Repeat Function:
Tap the REPEAT BUTTON (#16) again. The repeat icon will turn off.
SKIP AND SEARCH MODE
1. During Play or Pause mode, tap the BUTTON (#19) or
BUTTON (#20)
to go to the
next track or go back to the beginning of the current track.
2. During play mode or Pause mode, press and hold the BUTTON (#19) or
BUTTON
(#20)
to search a particular section within the current track with audible high speed
playback.
PROGRAM PLAY MODE
This function allows music tracks to be played in a programmed sequence.
Note: Program can only be set in STOP mode.
1. Press and hold the PROGRAM BUTTON (#17). The program number P01 will light and
the program icon “PROG” will flash on the LED DISPLAY (#1).
2. Tap the BUTTON (#19) or
BUTTON (#20)
to select the track to be programmed.
3. Tap the PROGRAM BUTTON (#17) again to confirm the selection. The program number
will advance to P02 and ”PROG” will flash to prompt for the next input.
4. You may repeat steps 2 to 3 to program up to 20 tracks. As soon as you have entered the
20th track, the display will show “FUL”.
5. Press the PLAY/PAUSE BUTTON (#18) to start playback in order.
6. Press the CD STOP

BUTTON (#21) to stop playback and press it twice to clear all
programmed tracks. The program icon “PROG” will go off.
Note:
Normally all the programmed tracks will be played through once and then stop. However, you
may use the REPEAT function to repeatedly play a certain track (Repeat 1) or all tracks
(Repeat All) in the program. You may also tap the BUTTON (#19) to go directly to other
tracks ahead or the
BUTTON (#20)
to go back to previous track(s) during program play.