Need help?Do you have a question about the STUDER REVOX B77 and is the answer not in the manual?
General| Type | Reel-to-reel Tape Deck |
|---|---|
| Tracks | 2 |
| Heads | 3 (Erase, Record, Playback) |
| Output Impedance | 600 Ω |
| Power Consumption | 50 W |
| Tape Speed | 19 cm/s |
| Reel Size | 10.5 inch |
| Frequency Response | 30 Hz - 20 kHz (7.5 ips) |
| Signal-to-Noise Ratio | 60 dB |
| Input | Line |
| Output | Line Level |
| Power Supply | 220-240 V, 50/60 Hz |
| Track System | 2-track, stereo/mono |
Details specific operational controls like PHONES, DOLBY NR, MPX FILTER, 0 dB-TONE, and RECORD CAL.
Presents technical specifications and signal-to-noise ratio measurements for the DOLBY version.
Lists plug-in circuit boards for DOLBY operation: input, record, replay, and monitor amplifiers.
Details the power supply board and connected units for tape transport control and motor speed.
Explains the input amplifier and DOLBY record processor, including calibration controls.
Describes the DOLBY replay processor and the calibration potentiometer board.
Details checks for the DOLBY input amplifier, including settings and measurements.
Explains setting replay levels using a test tape and specific controls.
Outlines the procedure for adjusting recording levels.
Describes methods for performing weighted and unweighted noise measurements.
To Next Page