EasyManuals Logo

Studer D21m User Manual

Studer D21m
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
II
The mains supply disconnect device is the mains plug. It must remain
accessible so as to be readily operable when the apparatus is in use.
If any part of the mains cord set is damaged, the complete cord set should
be replaced. The following information is for reference only. The wires
in the mains lead are coloured in accordance with the following code:
Protective Earth (Ground): Green/Yellow (US: Green or Green/
Yellow)
Neutral: Blue (US: White)
Live (Hot): Brown (US: Black)
As the colours of the wires in the mains lead may not correspond with
the coloured markings identifying the terminals in your plug, proceed
as follows:
The wire which is coloured Green and Yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
earth symbol.
The wire which is coloured Blue must be connected to the terminal in
the plug which is marked with the letter N
The wire which is coloured Brown must be connected to the terminal
in the plug which is marked with the letter L
Ensure that these colour codes are followed carefully in the event of the
plug being changed
This unit is capable of operating over a range of mains voltages, as
marked on the rear panel.
Note:
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment gen-
erates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This Class A digital apparatus meets the requirements of the Canadian Inter
-
ference-Causing Equipment Regulations.
Cet appareil numérique de la Classe A respecte toutes les exigences du Règle
-
ment sur le matériel brouilleur du Canada.
Working Safely With Sound Although your new console will not make any noise until you feed it signals,
it has the capability to produce sounds that, when monitored through a moni-
tor system or headphones can damage hearing over time.The table below is
taken from the Occupational Safety & Health Administration directive on
occupational noise exposure (1926.52):
Permissible Noise Exposure:
Duration per day [h] Sound level [dBA, slow response]
8 90
6 92
4 95
3 97
2 100
1.5 102
1 105
0.5 110
<0.25 115
!
Safety Information

Other manuals for Studer D21m

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Studer D21m and is the answer not in the manual?

Studer D21m Specifications

General IconGeneral
BrandStuder
ModelD21m
CategoryRecording Equipment
LanguageEnglish

Related product manuals