Need help?Do you have a question about the Studer J37 and is the answer not in the manual?
General| Tracks | 4 |
|---|---|
| Tape Width | 1 inch |
| Frequency Response (at 15 ips) | 30Hz - 18kHz (±2dB) |
| Signal-to-Noise Ratio | 60 dB |
| Power Supply | 220 V, 50 Hz |
| Type | Multitrack Recorder |
| Tape Speed | 15 ips |
Provides essential steps for setting up and starting the tape recorder for first-time use.
Details the procedure for recording audio onto the tape, including sync recording.
Explains how to monitor audio signals during recording and playback processes.
Describes the process of playing back recorded audio from the tape.
Describes the component housing the record, replay, and erase heads.
Explains the system ensuring consistent tape tension for optimal recording and playback.
Explains the capstan and pinch roller responsible for driving the tape.
Describes the amplifier circuit responsible for the recording signal path.
Details the amplifier circuit for reproducing recorded audio signals.
Outlines the process for setting up the playback channel for optimal performance.
Details the steps for adjusting the record channel for accurate audio input.
Explains how to measure tape speed fluctuations and slippage.
To Next Page
