EasyManua.ls Logo

STUDIO DUE CS-4 - Page 3

STUDIO DUE CS-4
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INTRODUZIONE
Vi ringraziamo per l’utilizzo del CS-2/CS-4, il nostro rivoluzionario faro PAR-64 mobile.
Il CS-2 / CS-4 sono proiettori di nuovissima concezione, pensati esclusivamente per arricchire le scenografie tradizionali dove si
utilizzano i PAR-64 permettendo moltissime scene con poche unità, questo comporta anche velocità d'installazione e riduzione
di spazi per il trasporto. Il CS-2 è l'unità con 2 fari PAR-64 che monta 2 lampade Air Craft 250W 28V le lampade possono essere
dimmerate separatamente da due canali DMX, anche il movimento PAN può essere regolato a 8 o 16 bit singolarmente da 2 canali
DMX, mentre per il movimento TILT 8 o 16 bit è comune per entrambe i PAR-64. Il CS-4 in più ha altri 2 spot PAR 64 e raggiunge
una lunghezza di 200 cm. Sia il CS-2 che il CS-4 utilizzano 20 canali DMX come da schema a pag. 4.
•Art. 0308 CS-2 per 2 lampade alogene Air Craft 250W 28V. oppure ST-250W-28V
•Art. 0309 CS-4 per 4 lampade alogene Air Craft 250W 28V. oppure ST-250W-28V
Il protocollo di ingresso è il DMX 512. Per il pilotaggio del CS-2/CS-4 raccomandiamo l’utilizzazione delle nostre centraline Control
Show 512, Fancy o Easy Control che sono in grado di pilotare i CS-2/CS-4 in modo ottimale.
Per ottenere il meglio delle prestazioni ed un corretto funzionamento negli anni di questa unità, Vi consigliamo di leggere at ten ta -
men te questo manuale prima di collegarla e metterla in uso. In questo modo acquisirete familiarità con i suoi comandi e col le ga men ti
affinché possiate utilizzarla facilmente.
VOSTRA REFERENZA
Citate il numero del modello e di serie ogni volta che Vi rivolgete al vostro rivenditore per informazioni o assistenza.
CONFEZIONE BASE
La confezione base del proiettore CS-2/CS-4 contiene:
• Proiettore
• Lampade (su richiesta)
• Staffe di fissaggio
• Manuale d’uso
• Garanzia Studio Due
INTRODUCTION
Thanks for choosing our CS-2/CS-4, the innovative mobile PAR-64.
CS-2 / CS-4 are projectors of the last generation, exclusively created to enrich traditional scenographies where the PAR- 64 are
used, allowing the use of a great number of scenes yet using only a few units: this also means a fast installation and the reduction
of space for the transport. The CS-2 is the unit with 2 PAR-64 lights, using 2 Air Craft 250W 28V lamps: the lamps can be separately
dimmered by 2 DMX channels, and also the PAN movement can be individually regulated at 8 or 16 bit by 2 DMX channels, while
the TILT movement at 8 or 16 bit is the same for both the PAR-64. The CS-4 is equipped wih the addition of 2 spots PAR 64 and has
a length of 200 cm. Both the CS-2 and the CS-4 use all the 20 DMX channels used as shown on the schematics on page 4.
•Art. 0308 CS-2 for two halogen lamps Air Craft 250W 28V. or ST-250W-28V
•Art. 0309 CS-4 for four halogen lamps Air Craft 250W 28V. or ST-250W-28V
the input protocol used is the DMX 512. We suggest to use our controller Control Show 512, Fancy o Easy Control which can op-
timally drive the CS-2/CS-4.
To make the best of the performances, and to achieve the perfect functioning of this unit throughout te years, we do suggest you
to carefully read this manual before connecting and switching on the unit. This will easily help you to become familiar with its
commands and connections, and easily use it
YOUR REFERENCE
Please always mention the serial number and model every time you address the seller for any information or assistance
BASIC KIT
The basic kit of the CS-2/CS-4 projector contains:
• Projector
• Lamps (upon request)
• Fixing plates
• User’s Manual
• Studio Due warranty
Controllate che l’apparecchio non abbia subìto alcun danno durante il trasporto.
Se avesse subìto dei danni o se non dovesse funzionare, rivolgetevi al vostro rivenditore. Se l’apparecchio vi è
stato spedito di ret ta men te, rivolgetevi immediatamente alla ditta di trasporto. Solo il destinatario (la persona o
ditta ricevente l’apparecchio) può re cla ma re per questo tipo di danni.
IMPORTANTE
!
Check that the spot has not been damaged during transport. If it has been damaged or it does not work, address
the seller. Whether the spot has been shipped to you directly, please contact the shipping company.
Only the consignee (person or company) can claim for these damages.
WARNING
!
eng
ita
... 2 ...