You can select the MIDI channel (value 1-16) for each Zone, to control 2 different external devices
Rotating the encoder, after having moved the focus on the parameter by clicking on it, you can
control the selected part Volume, in a range from 0 to 127; the Zone volumes can be controlled
directly also not in EDIT mode, when the MIDI button is lighted and the cursor-focus is on one of
Once you have selected the SPLIT point for the current PROGRAM (ref: PROGRAM EDIT) you can
decide where the selected ZONE should play, in a totally independent way as it follows:
TO LEFT: the zone will play to the left section of the keyboard (from A0 to the SPLIT note);
TO RIGHT: the zone will play to the right section of the keyboard (from the SPLIT note to C8);
TO ALL: the zone will play with no split all over the keyboard.
Even with one common SPLIT point (programmable for each PROGRAM) the possible settings are
almost one hundred, considering the status and combinations of
LOWER+UPPER+ZONEA+ZONEB and the SPLIT settings made possible by this function.
This function allows to transpose a Zone; differently from the GLOBAL TRANSPOSER, that will
effect the entire instrument, this function can be set independently for each MIDI zone and stored
in each PROGRAM, with different values.
You can set the octave (intervals of 12 semitones each) separately for each Zone; normally you will
need to move a zone one or two octave up, to the LEFT Zone of a split keyboard, to play chords in a
better range. On the other way, sometimes you can get a better sound if you move the UPPER zone
one or two octaves down; simply experiment the setting you prefer and then store it in the current
Here you can decide if the pedals are enabled or not for each Zone independently, according to
User manual - Numa Compact X SE https://www.studiologic-music.com/support/articles/ncxse_manual/?l...
28 di 32 01/03/2024, 13:41
To Next Page
Loading...
