where the cursor-focus is set (on ZONE A or ZONE B).
As for the pedals, also the Sticks can be enabled separately for the Zones; please note that the Stick
2 will be set automatically to AUTO if the related FX-AUTOSET function is set to ON in the
GLOBAL EDIT area. To control the Stick 2 assignment manually, you can set to OFF the FX-
AUTOSET and the function can be switched ON or OFF and stored in the Programs.
This parameter enables or disables the aftertouch function on the selected Zone; the function of
the Aftertouch will be in most cases similar-same of the Stick 2 modulation control, adding some
kind of vibrato or similar modulation to the sound, according to the setting. Normally you will set
the Aftertouch ON for the UPPER zone, that is commonly used for the main musical zone or solo
performances, while the LOWER zone is normally associated to accompaniments or bass lines, if
the SPLIT is active, however the setting is totally under your control and choice.
Selecting one of the pages dedicated to Sliders programming, moving one of the Sliders will
automatically enable the selected editing for that Slider; repeating the procedure for each Slider
will allow you to make the complete Sliders programming, for the various functions and settings.
All sliders settings can be memorized in any Programs, with same procedure of the Store Function.
This page allows to select the CC function for each one of the nine sliders, some selection is only
numeric, if the related CC is generally undefined by a standard, while others are also referring to
the name of the function, in addition to the number, such as cc 64 = Damper etc.
Selecting this function, for each slider, you can decide the MIDI value sent by the Slider when is
moved on the lowest position, (with the function programmed in the page CC Slider).
Selecting this function, for each slider, you can decide the MIDI value sent by the Slider when is
moved on the top-highest position.
The MIN and MAX Sliders values determine the total range of the selected function, as well as the
direction of the programmed control.
Setting the MIN Slider to hi values (for instance 127) and the MAX Slider to lower values (for
instance: 0) the result is a reversed control, from MAX (top position) to MIN (lowest position) as
User manual - Numa Compact X SE https://www.studiologic-music.com/support/articles/ncxse_manual/?l...
29 di 32 01/03/2024, 13:41
To Next Page
Loading...
