What to do if my Sturdy SA-300VMA Steriliser says 'E107: USB is full'?
If the Sturdy Steriliser displays the error 'E107: USB is full', it means the storage medium has reached its maximum data limit. You should immediately back up the data onto a secure zone. Then, follow the procedure '7.5.2.4 Download' to download the last record.
Why does the display of my Sturdy Steriliser not turn on?
If the Sturdy Steriliser shows no display, first, ensure that the main switch is turned on. Next, check if the power cable is properly plugged in. Also, verify that there are no bad connections. If the problem persists, contact your local distributor for service.
What to do if my Sturdy SA-300VMA Steriliser displays 'E108: USB formatter error'?
If your Sturdy Steriliser displays the error 'E108: USB formatter error', try re-formatting the USB flash drive. If that doesn't work, replace it with another USB flash drive. If the problem continues, contact your local distributor for service.
What to do if my Sturdy Steriliser displays 'E105: No USB memory'?
If the Sturdy Steriliser displays 'E105: No USB memory', insert a USB flash drive. If a USB drive is already inserted, detach and re-insert the memory card again.
What to do if my Sturdy Steriliser displays 'E135: Abnormal of the cycle'?
If your Sturdy Steriliser displays the error 'E135: Abnormal of the cycle', check the power supply to the Autoclave. If the issue persists, contact your local distributor for service.
What to do if my Sturdy Steriliser displays 'E109: EEPRM fail'?
If the Sturdy Steriliser displays the error 'E109: EEPRM fail', replace the USB flash drive with another one. If the problem continues, contact your local distributor for service.
What to do if my Sturdy SA-300VMA displays 'E155: Password fail'?
This function is reserved for diagnostic purposes by the manufacturer and is password protected. Contact your local distributor or the manufacturer for information.
Details installation environment requirements for optimal performance and interference elimination.
Step-by-step guide for physically placing and connecting the sterilizer unit.
Specifies the product's purpose and application for sterilization of various items.
Details the physical components and features of the autoclave sterilizer.
Outlines general operation, Re-Dry, Liquid programs, and test cycles.
Guides on preparing for sterilization and running the standard sterilization program.
Covers advanced programs, safety features, and item placement.
Explains the recorder's purpose, intended use, and the data it captures.
Details the recorder's controls, display, operational modes, and configuration.
Covers downloading data, printer settings, and resolving recorder issues.
Explains biological indicators for validating sterilization cycles.
Details the procedure for performing the Bowie-Dick test for air removal.
Describes the process and interpretation of the Helix test for load penetration.
Provides daily and weekly cleaning and inspection procedures for the sterilizer.
Details monthly cleaning and annual checks, including gasket replacement.
Lists common problems encountered with the sterilizer and their potential causes.
Provides a comprehensive list of error codes and their meanings.
General| Brand | Sturdy |
|---|---|
| Model | SA-300VMA |
| Category | Steriliser |
| Language | English |
To Next Page