How to use force start function?
1.Long press the force start button for 3 seconds. The green indicator light would
be on.
2.Once the green indicator light is on, you need to start your car within 30
seconds.
3.When the car is started successfully, the red indicator light would be on.
Disconnect the jump starter from the car battery.
How to charge your electronic devices?
1.Choose the right charging cable for your electronic device.
2.Connect the USB cable to the USB1/USB2 output port of the product. Or,
connect the TYPE-C cable to the TYPE-C port of the product.
3.Connect the other end of the cable to your electronic device such as your
cellphone and tablet.
4.Press the power button and the product will start charging the connected device.
How to use the flashlight?
Long press the power button to turn on the flashlight. Short press the power button
to switch modes: Solid → SOS warning mode → Flash mode → Off. Double press
the power button to turn on/off red warning light.
Features of smart battery clamp
1.Battery voltage detection. If the detected voltage is abnormal, alarm would be
set off (the red indicator light stays on and the buzzer beeps) and the output
would be turned off automatically.
2.Reverse polarity protection. If the clamps are connected to the wrong polarities,
alarm would be set off (the red indicator light stays on and the buzzer beeps)
and the output would be turned off automatically.
3.Detect defective battery. If the car battery is severely damaged, alarm would be
set off (the red indicator light stays on and the buzzer beeps) and the output
would be turned off automatically.
4.Reverse charging protection.
5.Force start function.
Warning
1.Make sure that the EC5 plug of the clamp is securely inserted into the jumping
port. Otherwise the plastic part of the clamp may melt.
EN-5
To Next Page
Loading...
Need help?
General
