Sub-Zero 245 - Framed Panels; Framed Panel Dimensions

Planning Information
Undercounter Model 245
Dimensions in parentheses are in
millimeters unless otherwise specified.
5
FRAMED PANELS
Framed door panels must be
1
/4" (6) thick around the
perimeter. If the panel is thicker than
1
/4" (6), an edge must
be routed around the panel to ensure a proper fit. The
edge must be
1
/4" (6) thick and you must allow
3
/8" (10)
around the perimeter for the frame. Model 245 requires no
handle recess. Refer to the illustrations on this page.
IMPORTANT NOTE: The Model 245 lower hinge extends
out from the side of the unit in the area of the kickplate.
When the unit is installed tightly against a full-depth panel
or cabinet, there can be interference. Refer to the full-scale
illustration on pge 6.
The overlay door panel design application is not available
for the Model 245.
IMPOR
TANT NOTE:
The weight of the panel cannot
exceed 20 lbs (9 kg).
FRAMED PANEL DIMENSIONS
Door Panel Width 23
1
/2" (597)
Door Panel Height 28
1
/8" (714)
Maximum Panel Weight 20 lbs (9 kg)
W
H
F
r
amed Door P
anel
Framed door panel
1
/4" (6) thick or less
Framed door panel thicker than
1
/4" (6)
P
ANELS
1
/4" (
6) THICK OR LESS
1
/4" (6) Panel
Trim reveal
1
/4" (6) min
PANELS THICKER THAN
1
/4" (6)
Trim reveal
1
/4" (6) min
Rout to
1
/4" (6)
thickness