2
|
English subzero.com
|
3
BUILT-IN REFRIGERATION
Contents
2 Built-In Refrigeration
3 Opening Dimensions
5 Dual Installation
5 Electrical
5 Plumbing
5 Preparation
6 Anti-Tip Bracket
7 Placement
7 Water Line
7 Custom Panels
9 Alignment
9 Completion
Important Note
To ensure this product is installed and operated as safely
and efciently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
Product Information
Important product information including the model and
serial number of the unit are listed on the product rating
plate. The rating plate is located at the top frame of the unit,
inside the door. Refer to the illustration below.
If service is necessary, contact your authorized Sub-Zero
dealer.
Tools and Materials
• Screwdrivers—standard and Phillips.
• Power drill.
• Drill bits (masonry bits required for concrete installation).
• Torx drives—T-10, 15 and 20.
• Standard Allen wrench set.
• Standard socket and wrench set.
• .6 m and 1.2 m levels.
• Tubing cutter.
• .9 m of
1
/4" OD copper, braided stainless steel or PEX
tubing.
• Saddle valve.
• Material to protect home, ooring and cabinetry during
installation.
Rating plate location.
RATING
PLATE
To Next Page
Loading...
Need help?
General
