To Next Page

To Previous Page

Wine Storage Use & Care 17

subzero.com

Cleaning

CONDENSER CLEANING

Clean the condenser area every three to six months. The

cleaning schedule will depend on the amount of dust and

lint that accumulates in this area.

For models 424G and 424FSG, the condenser is located

behind the kickplate. Remove the kickplate to expose the

condenser area. Refer to the illustration below.

The condenser for models 427G and 427RG is located

behind the kickplate/grille. Remove the screws holding the

kickplate/grille. This assembly will slide forward easily,

giving you access to the condenser area. Refer to the

illustration below.

For model WS-30, the condenser is located behind the

grille. Pull out on the bottom edge of the grill and tilt

forward for access to the condenser area. Refer to the

illustration.

Using a soft bristle brush, vacuum to remove dust and lint

from the condenser area.

IMPORTANT NOTE: To avoid bending the condenser fins,

be sure to vacuum in the direction of the fins (up and

down).

CONDENSER

Location of condenser

(424G and 424FSG).

Location of condenser

(427G and 427RG).

CONDENSER

Location of condenser

(WS-30).

Failure to clean the condenser could result in tempera-

ture loss or mechanical failure or damage.

Before cleaning the condenser, shut off power to the

unit at the control panel. Wear gloves to avoid injury

from sharp condenser fins.

Sub-Zero WS-30 Use & Care Guide

Other manuals for Sub-Zero WS-30