Black plate (135,1)
北米Model "A1920BE-B" EDITED: 2006/ 9/ 19
Illumination brightness con-
trol
When the headlight switch is in the “ ”
or “
” position, you can adjust bright-
ness of the instrument panel illumination
for better visibility.
To brighten, turn the control dial upward.
To darken, turn the control dial downward.
Headlight beam leveler (U.S.-
spec. WRX-STI)
The WRX-STI version has High-Intensity
Discharge (HID) headlights on the low
beam setting. The HID headlights gener-
ate more light than conventional halogen
headlights. Therefore a dri ver of an
oncoming vehicle may experience too
much glare when your headlight beam
height adjustment is hig h due to the
vehicle carrying heavy load.
The headlight beam leveler can be used
to adjust beam height to avoid such a
condition.
The higher the number the knob is turned
to, the lower the beam becomes.
Parking light switch
The parking light switch operates regard-
less of the ignition switch position.
By pushing the front end of this switch,
following lights will come on.
– Parking lights
– Front side marker lights
– Tail lights
– License plate lights
To turn off, push the rear end of the
parking light switch.
Avoid leaving these lights on for a long
time because that will run down th e
battery.
Instruments and controls 3-25
3
To Next Page
Loading...
Need help?
General
