Black plate (100,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
2-10 Keys and doors
ity reasons. It is recommended that you
have your dealer program all of your
transmitters into your system.
! Programming the transmitters
The keyless entry system is equipped with
a special code learning feature that allows
you to program new transmitter codes into
the system or to delete old ones. The
system can learn up to four unique
transmitter codes. The four transmitter
codes may be the same or different.
Programming transmitter codes into
system:
Bag containing transmitter
Transmitter circuit board
To register a new transmitter with the
keyless entry system, it is necessary to
program the transmitter’s code (identifica-
tion number) into the system. A label
showing the code is affixed to the bag
containing the transmitter, and another is
affixe d to the circuit board inside the
transmitter. If there is no bag, open the
transmitter case and make a note of the
eight-digit number. Program the number
into the system in accordance with the
following procedure:
1. Firmly close the doors and the rear
gate.
2. Open the driver’s door, sit on the
driver’s seat, and close the door.
3. Perform the following steps within 45
seconds.
1) Open and close the driver’s door once.
1) ON
2) LOCK
2) Insert the key into the ignition switch,
then turn it from the “LOCK” position to the
“ON” position 10 times within 15 seconds.
To Next Page
