M
Automatic transmission
P = Park
To move gearshift from Park: Press rmly on brake pedal while
pressing select lever button in.
R = Reverse
N = Neutral
No gear engaged.
D = Drive
For normal driving: Shifts through ve forward gears automatically.
O
Cruise control
Cruise control operates when vehicle speed is 40 km/h (25 mph) or more.
1
To activate:
Push
CRUISE
button.
2
To set speed:
Push lever downward at desired speed and release it.
3
To increase the speed:
Push lever upward and hold it, release at desired
speed; or depress accelerator pedal, push lever downward and release
it at desired speed. (Incremental acceleration: Push lever upward and
release it, each tap equals an increase of 1.6 km/h [1 mph].)
4
To decrease the speed:
Push lever downward and hold it, release at
desired speed; or tap brake pedal, push lever downward and release it
at desired speed. (Incremental deceleration: Push lever downward and
release it, each tap equals a decrease of 1.6 km/h [1 mph].)
5
To temporarily cancel:
Pull lever back or tap brake pedal, shift automatic
transmission selector lever into
N
. Return to preset speed after it has been
cancelled: push lever upward and release it.
6
To deactivate:
Push
CRUISE
button. Cruise control is always deactivated
when ignition switch is turned to
ACC
or
LOCK
.
1
3
6
2
5
4
Rear-view camera (if equipped)
When the ignition switch is
ON
and the selector lever is set to
R
, the rear-view camera automatically
displays the rear-view image from the vehicle.
SPORT mode:
SPORT mode is used when power is needed for rapid acceleration or for uphill driving.
To select SPORT mode, simply move select lever from
D
to manual gate.
SPORT
light will come on in
combination meter.
MANUAL mode:
To select MANUAL mode, move the select lever from
D
to manual gate, then move it to the
+
end
or
-
end of the manual gate. When MANUAL mode is selected, the gear position indicator and
upshift/downshift indicator in the combination meter come on.
N
Traction Control System OFF switch
To deactivate Traction Control System, push button.
light in combination meter will come on.
Deactivation should not be used except when absolutely necessary.
To Next Page