Need help?Do you have a question about the Subaru XV CROSSTREK HYBRID 2014 and is the answer not in the manual?
General| Brand | Subaru |
|---|---|
| Model | XV CROSSTREK HYBRID 2014 |
| Category | Automobile |
| Language | English |
Details engine type, valve arrangement, bore, stroke, displacement, and compression ratio.
Details transmission type, clutch type, and gear ratios for hybrid and non-hybrid models.
Details final reduction gear type and ratio for the CVT transmission.
Highlights high voltage hazards and required training for hybrid system maintenance.
Details the procedure for removing and handling the service plug to isolate high voltage.
Guidelines for towing damaged hybrid vehicles, emphasizing safety precautions.
Safety precautions during repair of damaged hybrid vehicles, including fluid handling.
Safety measures for handling high voltage batteries, including disposal and collision impact.
Diagram illustrating the wiring for the brake vacuum pump relay and its control.
Details the system that emits sounds to warn pedestrians of the vehicle's presence.
Explains power flow when the engine is the primary driving force.
Explains power flow when the vehicle operates solely on electric power.
Explains power flow during engine operation to charge the hybrid battery.
Explains how kinetic energy is converted to electrical energy during deceleration.
Provides electrical storage for conventional starter and vehicle operations.
Provides electrical storage for the Integrated Starter Generator (ISG).
Provides electrical storage for EV Mode operations and charges the auxiliary battery.
Explains the role of contactors and the pre-charge circuit in managing battery power.
Describes the sensors used to monitor the temperature of the high voltage battery.
Details the ISG's function in starting the engine and charging the battery.
Describes system operation when the engine starts and before auto start/stop engages.
Explains system behavior when the vehicle is stopped and the engine turns off.
Illustrates the routing and connection of high voltage wires for the hybrid motor.
Step-by-step guide for safely removing the service plug before battery work.
Details the Hybrid Electric Vehicle CAN network and its functions.
Details the Power Unit CAN network and its control functions.
General precautions and normal vehicle behaviors to consider during diagnostics.
Information on using the BECM select monitor for diagnostic data.
Step-by-step troubleshooting for DTC P0AA6, High Battery Voltage Isolation Fault.
Details the six levels of failsafe controls and their impact on vehicle operation.
Procedure for removing the V-belt tensioner assembly and the V-belt.
Steps for installing the V-belt tensioner assembly and V-belt with torque values.
To Next Page
