35
– CONTINUED –
The rear center seatbelt is stowed in the
seatbelt holder on the right side of the car-
go area.
1. Raise the head restraint to the extend-
ed position. Do not remove the head re-
straint.
2. Remove the tongue plate from the belt
holder and pull out the seatbelt slowly.
3. After drawing out the seatbelt, pass it
through the belt guide as follows: First in-
sert one edge of the belt into the open gap
in the belt guide; then slide the rest of the
belt in, so that the whole belt fits inside.
4. After confirming that the webbing is not
y Be sure to fasten both tongue
plates to the respective buckles. If
the seatbelt is used only as a
shoulder belt (with the connec-
tor’s tongue plate not fastened to
the connector’s buckle on the
right-hand side), it cannot proper-
ly restrain the wearer in position
in an accident, possibly resulting
in serious injury or death.
y Be sure to raise the head restraint
to the extended position before
passing the seatbelt through the
belt guide. Using the belt guide
with the head restraint at the re-
tracted position may result in seri-
ous injury.
102117
102107
101597
100309
B1301AE-A.fm 35 ページ ２０１６年８月２９日 月曜日 午前１０時４分
To Next Page
Loading...
