SUBLIMATION Vacuum Heat Press Machine - Safety Instructions; General Safety Precautions

Contents
P2. Safety Instructions
P3. Contents
P4. Features
P5. Compatible Products
 P6. TechnicalSpecications
P7. Inside the Box
P8. Operation Instructions
P10. The Vacuum Tray
P11. Replacing Parts & Draining Filter
P12. Producing Mugs
P13. Producing Plates
P14. Producing Phones (Metallic Sheet Method)
P15. Producing Phones / Tablets (Plastic Full Cover)
P16. Producing Acrylic Frame
P17. Producing Ceramic Tile
P18. Troubleshooting
Important Safety Instructions
When using your 3D Sublimation machine, basic precautions should
always be used including the following points:
1. Read all instructions
2. Use 3D Heat Press only for its intended purpose
3. To reduce the risk of electric shock do not expose the 3D Sublimation
Vacuum Heat Press to water or other liquids.
 4.Whennishedwithmachine,turnunitoffbeforedisconnecting
the plug from the socket. Never pull the cord to disconnect from
power outlet. Instead grasp plug and pull to disconnect.
5. Do not allow power cord to touch hot surfaces. Please ensure the
3D Heat Press has cooled completely before putting away.
6. Do not operate appliance with a damaged power cord, or if the
appliance has been dropped or damaged.
7. To reduce the risk of electric shock, do not disassemble or attempt
to repair the 3D Heat Press. Please contact your reseller for
examination and repair (based on the terms of your warranty).
 Incorrectreassemblyorrepaircouldcauseariskofre,electric
shock, or injury to persons when the appliance is used.
Any attempt to repair or tamper with the unit will void warranty.
8. Children are not allowed to operate this appliance, please do not
leave the appliance unattended while connected.
9. Severe burns could occur from touching hot metal parts.
10. To reduce the likelihood of circuit overload, do not operate
another high voltage appliance on the same circuit
11. If an extension cord is absolutely necessary, a 20 amp rated cord
should be used. Power cords rated for less amperage may overheat,
care should be taken to arrange the cord so that the power cord
cannot be pulled or tripped over.