Models 427 and 427R Installation 25
subzero.com
Side Panels
S
ide panels for models 427 and 427R are not attached to
the unit. You must securely fasten the panels to adjacent
cabinets and floor.
Panels should be fastened to the floor and walls using ‘L’
brackets (hardware not provided). To help you move the
unit into place, rout out an area in the floor so the ‘L’
bracket will sit flush with the floor level.
Anchoring
Brackets and screws are provided for mounting the unit to
adjoining cabinets and side panels. Each unit has four
side-mounting clips on each side.
IMPORTANT NOTE: For installations where you are not
attaching to a side wall, or you are installing two model
427, 427R or integrated units together, you must remove
the side-mounting clips before moving the unit into
position. After removing the clips, replace the screws into
the appliance.
A dual installation heater kit (7007529) is necessary for
anchoring two model 427, 427R or integrated units
together. The kit is available through your Sub-Zero dealer,
or call Sub-Zero at 800-222-7820. You can also visit our
website at subzero.com.
90° Door Stop
Models 427 and 427R have a 90° door stop built into the
hinge system. Use the blade edge of a standard screw-
driver and rotate the brass cam in the center portion of
the hinge until you reach the stop. You must make this
adjustment to both the bottom and top hinge. Refer to the
illustration.
Completing the Installation
IMPORTANT NOTE: When you have completed the instal-
lation of the model 427 or 427R wine storage unit, refer to
page 50 for an installation checklist and page 51 for
service information.
90° door stop.
To Next Page
Loading...
