SLAVE FUNCTIONS
1. LINE OUT
Use this output to connect to further slave subs.
2. LINE IN
Use this input to connect to the SUB OUT on the
Master sub.
3. POWER / SIGNAL / LIMIT
Use the LED signifiers to assess the current status
of the Modular Column at a glance.
4. VOL
Adjust this knob to control the overall volume of
the slave subwoofer.
5. VOLTAGE ADJUSTER
Use this to switch between 115V and 230V.
Please ensure the setting matches your local
supply before switching on the unit.
6. MAIN POWER INPUT
Use the supplied mains cable to provide power
to the unit via a mains socket. Please note only
use the same type of fuse that comes installed
from the factory.
7. POWER ON/OFF
Use this to turn the unit on and off.
7
To Next Page
Loading...
Need help?
General
