Subzero SZ-VOXLINK-COMPACT-4H/L User Manual

12
OPERATION
SZ-VOXLINK-COMPACT - 2H/L
Power On/Off: To switch on the receiver or
bodypack transmitter, press and hold the power
button until you see the power indicator light
(approx 2 seconds). To switch on the handheld mic,
press and hold the power button until you see ‘On’
appear in the display (approx 2 seconds).
To switch off the receiver or bodypack transmitter,
press and hold the power button until you see the
power indicator go off (approximately 2 seconds).
To switch off the handheld microphone, press and
hold the power button until you see ‘OFF’ appear in
the display (approximately 2 seconds).
Frequency Adjustment: The system has 3 pre-set
frequencies for each channel, and you can switch
between them by pressing the set button on the
transmitter. The receiver will automatically pair
with the transmitter without requiring further
adjustments, provided that Intelligent Scanning
mode is enabled (see below).
Intelligent Scanning & Fixed Frequency Mode:
When Intelligent Scanning Mode is enabled, the
receiver will automatically detect the transmitter
frequency and synchronise with it. When Fixed
Frequency Mode is enabled, the receiver will not
automatically synchronise with the transmitter if you
switch transmitter frequencies.
To determine the current mode:
1. Switch on the receiver as described above, and
watch the power indicator.
2. If the power indicator flashes 3 times just after the
receiver has been switched on, this indicates that
Fixed Frequency Mode is enabled. If it does not
flash, Intelligent Scanning Mode is enabled.
To swap between Intelligent Scanning Mode and
Fixed Frequency Mode:
1. Switch on the receiver as described above.
2. Press the power button as if switching off the
receiver, but keep the button pressed after
the power indicator has gone off until you see
the indicator flash 3 times. This will be about 8
seconds after the receiver has powered off.
Charging: The receiver and body-pack transmitter
have built-in batteries. When the battery is low, the
charging indicator will flash, indicating that it’s time
to recharge.
SZ-VOXLINK-COMPACT - 4H/L
Power On/Off: To turn on or off the device, press
and hold the power button for one second.
Transmitter A / B/C/ D Channel Switching: To switch
between channels A, B, C, and D press and hold the
set button for two seconds to perform a channel
search.
Frequency Adjustment: The transmitter frequencies
are fixed, so the receiver will automatically pair
with them without requiring any manual frequency
adjustments.
Volume Adjustment: For information on how to
adjust the volume for the handheld microphone
and lavalier function, please refer to the “Set Button”
description.
Button Lock Mode Settings: This feature is only
available for the handheld microphone. Please refer
to the “Handheld Microphone Function” description
to learn how to enable the button lock settings.
Charging: The receiver is powered by a built-in
2000mAh lithium battery. When the battery is low,
the power blue indicator will flash at a frequency of
0.5 seconds, indicating that it’s time to charge. While
charging, the red indicator will remain constantly on
and turn off once charging is complete. Charging
time typically takes around three to four hours.

Subzero SZ-VOXLINK-COMPACT-4H/L Specifications

General

Brand	Subzero
Model	SZ-VOXLINK-COMPACT-4H/L
Category	Microphone system
Language	English