SF-8200 Operation Manual
10 / 76
4) The network power input socket is a disconnect device for the power supply of the instrument and the
network. Do not install this device in a hard-to-disconnect position.
5) The analyzer contains non-corrosive gases, non-toxic gases, no special ventilation requirements.
Figure 1.2 Instrument Installation Environment
2.3 WORKING ENVIRONMENT
1) Installation category: II (overvoltage category)
2) Class of pollution: II
3) Voltage: AC100-240V（50Hz）
4) Temperature: 15℃～30℃（23℃ best）
5) Relative humidity: Not exceed 75%（30% - 75% best）
6) Barometric pressure: 86.0kPa～106.0kPa
7) Operation system: Win98/ME/WINNT4/WIN2000/WINXP/WIN7/WIN10
8) Avoid direct heat and light exposure
WARNING: Make sure the instrument is grounded. Improper grounding may cause electric
shock.
2.4 PERIPHERALS
1) The computer system is not less than the following configuration:
CPU: frequency 1GHZ above, 32-bit or 64-bit processor;
Display: VGA color display, supports 1024 × 768 resolution and above;
Hard disk: at least 16 GB of free space (based on 32 bits) or 20 GB of free space (based on
64 bits)
Memory: The minimum requirement is at least 1G, more than 2G recommended;
Graphics Card: DirectX 9 graphics device with WDDM 1.0 or later driver;
Operating System: Correct preinstalled Win98 / ME / WINNT4 / WIN2000 / WINXP / WIN7 /
WIN10 operating system;
Printer: support for the operating system and motherboard
2) External socket
① USB (IC card)
② RJ45
③ Power cord
To Next Page
Loading...
Need help?
General