Need help?Do you have a question about the Süd wind AMBIENTIKA and is the answer not in the manual?
Step to remove the protective label before using the remote controller.
Explains the sleep mode with active sensors and automatic extraction based on parameters.
Details automatic operation of extraction/intake, sensor checks, and speed adjustment based on light.
Describes manual speed setting for extraction and intake, noting sensors are inactive.
Allows changing humidity intervention levels for continuous extraction at full speed.
Controls simultaneous input/extraction, reversing direction for balanced environments with paired products.
Activates air pumping for multiple units, with sensors inactive.
Activates air extraction for multiple units, with sensors inactive.
Procedure to reset the filter alarm and hour counter after 2000 operating hours.
Steps to set up wireless products for communication and define master/slave roles.
Steps to reset the product to default configuration, with differences for versions.
Guide on replacing the remote controller battery when it no longer responds.
To Next Page
General