Need help?Do you have a question about the Sugden A21SE Signature and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Remote Control | No |
| Power Output | 30 Watts into 8 Ohms |
| Inputs | 5 x Line Level |
| THD | <0.1% |
| Outputs | Pre-Out |
Includes AC power lead with IEC connector and owner registration card.
Ensure adequate ventilation (10cm clearance) and avoid heat sources/tape recorders.
Connect to mains via supplied AC cable, matching country voltage rating.
Avoid specialist mains blocks or power supplies to maintain sound quality.
Use good quality cables. L.T.V.S socket supports Stage One phono amplifier.
Use gold-plated binding posts for 4-16 Ohms speakers; follow bi-wiring instructions.
Connect via RCA phono sockets, marked L/R, for line-level components like CD players.
Provides Tape Output (fixed) and Pre-amp Output (variable) for recording or external amps.
Motorized control adjusts listening level; zero volume at anti-clockwise position.
Rotary switch to select one of five inputs; operate with minimal effort.
Fuse replacement by technician; determine fault first, never bypass or change spec.
HT fuses protect power boards; mains fuse is externally accessible at the rear.
Identifies Inputs, Line Output, Loudspeakers, and Mains Input & Fuse sockets.
Shows Power, Power Light, Volume Control, Remote Eye, and Input Selector.
Max Power Consumption: 300 Watts. Power Output: 40W Class A (4 Ohms), 30W Class A (8 Ohms).
Frequency Response: 12Hz to 141kHz. Bandwidth (wide): 6Hz-280kHz.
Signal to Noise Ratio: >90dB. Input Sensitivity: 110mV. Input Impedance: 50K.
To Next Page
