th member
Collar
Max.1mm
撚り合わせる
Fold and strand the
strength member tightly
(Fig. 15)
(Fig. 13)
(Fig. 14)
(2) Fold bac
k the strength member yarn
at about two strands and then insert
the optical fiber into the collar . (Fig.
13)
(3) Ins
ert the collar into the cord jacket.
Note: Please make the collar projected from
the cord jacket by no more than 1mm.
(Fig.14)
(4) Keep the strength member folded and
strand it tightly. (Fig.15)
(5) P
ut the optical fiber in protective coating
remover through guide hole from front
face (label face). (Fig.16 ,17)
(Fig. 17
)
Protective coating remover
(gu
ide hole)
Note:
Be careful not to nip the strength
member between the blade of the
remover, or the blades will be
damaged.
(Fig. 16
)
To Next Page
Loading...