Sumitomo CAK-0057-EX - Assembling Procedure for H-PCF Cables;Cords

To Next Page

To Previous Page

5. Assembling procedure for H-PCF cables/cords.

5.1 Preparatory work for optical fiber cables

(The work shown in this page is mentioned only for cables. In case of cords, please skip it and start

from the next page.)

Fig.3

(1) Remove the sheath by using your own

knife. (Fig.3)

Remove length ----- 200mm (Reference

value)

Fig.4

(2)

Cut off the hold tape, the filler and the

filler cords at the end of the sheath with

the scissors to expose the optical fiber

cords and the central strength member .

(Fig. 4 to 5)

Strength member

tical fiber cord

Fig.5

Protective boot

Fig.6

(3) Insert the optical fiber cords and the

tension member into the protective boot

and cover the end of the sheath with the

protective boot. (Fig. 6)