Sumitomo T-400S Quick Reference Guide

Ver1.03
Icons on the initial screen
Shows a selected
vi
e
w
type
.
Press key to open the setup pane.
Connector
Install the battery pack in the
correct orientation.
With the wires and strap facing
outside, install the battery and
connect the connector completely.
The Function keys
correspond to the
icons located on the
left upper corner of
the screen.
Battery
charging
status LED
SET key
RESET key
Heat shrink
oven key
Power key
Selected splice pro-
gram /heater program
is displayed.
Strap
Quick Reference Guide
Correspond to
keys on the
left hand key pad.
The left-hand keys are sometimes used to
move the cursor “
” up and down, and to left
and right.
Icons on the setup pane
Go to Function setup
screen.
Right-hand key pad
Left-hand key pad
OME1624008
Keypad
Enter
Splice program
Go to Pass Code entry
screen to log in to the
Administrator mode.
Heater program
Choose to perform
an arc test.
A message for key
guidance is dis-
played.
Shows a power
source type being
used.
T-400S

Sumitomo T-400S Specifications

General

Fiber Alignment	Core Alignment
Typical Splice Loss (SM)	0.02dB
Typical Splice Loss (MM)	0.01dB
Typical Splice Loss (DS)	0.04dB
Typical Splice Loss (NZDS)	0.04dB
Return Loss	≥60dB
Electrode Life	3000 splices
Automatic Heating Start	Yes
Operating Condition - Altitude	0 to 5000m
Category	Fusion Splicer
Model	T-400S
Applicable Fibers	SM, MM, DS, NZDS
Splicing Time	9 seconds
Applicable Fiber Protection Sleeve	40 mm, 60 mm
Data Output	USB
Power Supply	AC adapter, Battery
Operating Condition - Temperature	-10 to 50°C
Operating Condition - Humidity	0 to 95% (non-condensing)
Storage Condition - Humidity	0 to 95% (non-condensing)
Storage Condition - Battery Temperature	-20°C to 30°C (long term)
Manufacturer	Sumitomo
Type	Fusion splicer
Fiber Type	SM, MM, DS, NZDS
Core Diameter	125µm
Cladding Diameter	125 µm
Operating Temperature	-10°C to 50°C
Storage Condition - Temperature	-20°C to 60°C
Storage Temperature	-20°C to 60°C