SUMMER WAVES RX600 - SETUP INSTRUCTIONS; Suction and Return Fittings Installation; Pump and Hose Installation

10
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
1. Set up your pool following the pool Owner's Manual instructions. Do NOT
fill water until the Filter Pump is properly installed. Locate the Outlet and
Inlet openings on the pool wall.
Suction & Return Fittings Installation
Pump Installation
3. From inside the pool, install the Return Fitting 6 into the Inlet opening.
2. From inside the pool, install the Suction Fitting 2 into the Outlet opening.
SETUP INSTRUCTIONS
4. Take out the Filter Pump Assembly , two Hoses and four Hose
Clamps 10 .
9
10
11
WARNING: CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Before assembly, take a few minutes to identify and become familiar with all the parts.
11
9
10
Inlet
Outlet
4
3
1
2
Outside Pool Wall
Inside Pool Wall
7
6
1
4
Outside Pool Wall
Inside Pool Wall