Summer 3Dpac CS - Accessories and Maintenance; Removing and Attaching Accessories; Car Seat Attachment Procedure

press!
press!
removing the tray:
removing the wheels:
attaching a car seat:
Summer™ Affirm™ 335, Graco
®
SnugRide
®
Click Connect
™
35, Graco
®
SnugRide
®
SnugLock
®
35, Chicco
®
Keyfit
®
30, Chicco
®
Fit2
®
and Baby Trend
®
Secure Snap Gear
®
35
Use this section
to attach car seat
models:
To remove, press the buttons on the
side of stroller.
Each wheel has a release tab. Pull the release
tabs out to remove wheels from frame.
2
Fold canopy back.
3
Make sure seat is fully reclined.
11
• NEVER install Infant Car Seat without fastening it securely to the stroller with the provided car seat straps.
Car seat must be in rear facing position only.
• NEVER lift the stroller by infant carrier handle.
• Use only with Summer™ Affirm™ 335, Graco® SnugRide® Click Connect™ 35, Graco® SnugRide®
SnugLock® 35, Chicco® Keyfit® 30, Chicco® Fit2® and Baby Trend® Secure Snap Gear® 35 infant car
seats. Other car seats or carriers are not designed to fit this stroller frame and may result in serious injury or
death. NEVER use them as they have not been safety tested.
1
Remove tray.
press!press!
WARNING