Summit Audio TLA-100A - Electrical Connections; Side Chain; Stereo Link; Specifications

6
ELECTRICAL CONNECTIONS
INPUT:
(This TLA-100A is wired as a pin 2 hot device. Units made before March 1
st,
2003 come factory
wired with pin 3 hot.)
Unbalanced: 3 pin XLR Connector Balanced: 3 pin XLR Connector
Pin 1 – Ground Pin 1 – Ground
Pin 2 – (+) Signal Pin 2 – (+) Signal
Pin 3 – Connect to Pin 1 Pin 3 – (-) Signal
OUTPUT:
Unbalanced: 3 pin XLR Connector Balanced: 3 pin XLR Connector
Pin 1 – Ground Pin 1 – Ground
Pin 2 – (+) Signal Pin 2 – (+) Signal
Pin 3 – Connect to Pin 1 Pin 3 – (-) Signal
SIDE CHAIN:
Tip – Signal output (to EQ)
Ring – Signal input (from EQ)
Sleeve - Ground
Set the rear panel switch for the proper position.
STEREO LINK:
Tip – Signal
Sleeve – Ground
Use the shielded patch cord with ¼” plug
Note: When running an unbalanced output it is best to connect pin 3 to pin
1 in the connector that plugs into the TLA-100A.
The TLA-100A contains heat generating devices, ample ventilation needs
to be provided. Good ventilation will give long, trouble free operation.
THINK TUBES!!
SPECIFICATIONS