What to do if Summit Medical Equipment shows “OCL” and beeps constantly during infusion?
If your Summit Medical equipment displays “OCL” and beeps constantly during infusion, it indicates a fluid path occlusion. You should: * Verify that all tubing clamps are open. * Check access device patency. * Check for kinks in the tubing.
Why is my Summit Medical Equipment making a continuous tone?
A continuous tone from your Summit Medical Equipment indicates a malfunction. Here's what you can do: * If the battery icon is visible, replace the batteries, as it might be a dead battery alarm. * Ensure proper cassette placement by pressing on the cassette top. * Check the cassette, remove it from the pump, and rotate the cassette shaft counter-clockwise one time. * Replace the cassette onto the pump. * Press and release the RUN/PAUSE button to resume infusion. If “MA” continues, immediately close the tubing clamp. Manufacturer’s service/assistance may be required.
What to do if blood backed into tubing of Summit Medical Equipment?
If blood has backed into the tubing of your Summit Medical Equipment: * Verify the tubing is connected correctly, ensuring the patient side connects to the patient and the bag side connects to the bag. * Confirm that the pump is in run mode. * Attempt to clear the tubing by delivering a bolus. If unable to clear the tubing, close the tubing clamp and replace the cassette. If the issue persists, manufacturer’s service/ assistance may be required.
How to fix no display on Summit Medical Equipment?
If there is no display on your Summit Medical Equipment, check the following: * Ensure the battery cover is in the ON position. * Verify proper battery placement. * Try replacing the batteries.
What to do if the cassette will not attach to the pump of Summit Medical Equipment?
If the cassette won't attach to the pump on your Summit Medical Equipment: * Verify proper cassette placement onto the pump. * Make sure that the cassette bottom disc has not been snapped into the cassette body.
Explains terminology, symbols, and crucial safety warnings for pump use.
Intended uses, pump modes (PCA, PIb, P+P), and infusion patterns.
Lists required materials and outlines sequential setup steps for the pump.
Instructions for cassette priming, attachment, removal, and battery installation/replacement.
Details PCA, PIb, P+P modes, programming steps, and program review procedures.
How to start, pause, resume infusions, activate boluses, and silence alarms.
Accessing, clearing history, and managing pump lockout modes for security.
Identifies alarms, common problems, and provides solutions for pump issues.
Pump specifications, delivery rate accuracy data, and factors affecting performance.
Pump cleaning, disinfection, warranty, and customer support contact information.
General| Brand | Summit Medical |
|---|---|
| Model | ambIT |
| Category | Medical Equipment |
| Language | English |
To Next Page