11
9) How to change P-sensor High Alarm setting
① To enter this mode, press [MODE / SET] and [UP or DOWN] until [Hi] is displayed.
② Then press [MODE / SET] to see current high temperature alarm setting.
③ To change the high temperature alarm setting, press [UP or DOWN] until the
desired value is displayed, then press [MODE / SET] to set the value.
10) How to change P-sensor Low Alarm setting
① To enter this mode, press [MODE / SET] and [UP or DOWN] until [Lo] is displayed.
② Then press [MODE / SET] to see current low temperature alarm setting.
③ To change the low temperature alarm setting, press [UP or DOWN] until the
desired value is displayed, then press [MODE / SET] to set the value.
※See the valid setting ranges for freezers and refrigerators in the chart on page15.
11) P-Sensor High temperature and low temperature verification and reset
① To enter this mode, press [MODE / SET] and [UP or DOWN] until [HL] is
displayed.
② Then press [VERIFY]. Then you will see the Highest temperature value of P-
Sensor after [H-] is displayed and the Lowest temperature value of P-Sensor after
[L-] is displayed. The Highest and Lowest temperature values of P-Sensor will be
shown in sequence.
③ Either to exit this mode, press [VERIFY] or to reset to default value, press [MODE
/ SET] for 2 seconds.
12) How to convert the temperature mode (F↔C)
① To enter this mode, press [MODE/SET] and [UP or DOWN] until [SE] is displayed.
② Then press [MODE/SET] and you will be able to see the current temperature set
mode with blinking sign either F or C.
③ To convert the temperature mode, press [UP or DOWN] until the desired mode is
displayed.
④ Then, press [MODE/SET] to fix the temperature mode.
⑤ Press [UP or DOWN] until [th] is displayed and then press [VERIFY] to exit the
mode.
To Next Page
Loading...
