Summit SBC58 Series - Installation of Cold Brew Tap Kit

15
Installation Instructions for Cold Brew Coffee Tap Kits
Flat Iced Coffee Kits: KitCF KitCFTWIN
Nitro-Infused Coffee Kits: KitNCF KitNCFTWIN
Combination Flat/Nitro Kit: KitCMTWIN
Parts & Equipment
(not included)
Installation
1. Put draft tower directly over the hole on the top of the coffee dispenser’s upper
surface. Fix the tower assembly with screws directly to the upper surface of the
dispenser. (See Fig. 1.)
3. Using a wrench, tighten the hex nut port on the regulator valve to the N
2
gas
outlet on the N
2
gas cylinder. (See Fig. 2.)
Fig. 1
Fig. 2