27 | P a g e
4.3.3 Pneumatic Brakes
Pneumatic brakes generally consist of two brake cylinders (one per wheel), a
pressurised air tank, a set of configured brake levers (Both usually located at
the rear of the machine closest the axle/wheels), and an REV (Typically located
near the front of the machine). For connection details, see Hitching and tractor
connections section of this manual.
Example System:
Our Homologated Pneumatic brake systems also include a Park/Shunt Valve
normally located at the front of the machine for temporary release of machine
brakes for shunting, if no tractor is available/connected. Press once only to
release brakes. Make certain to have a clear environment before release and
keep well clear of machine just incase it slides/moves unexpectedly. Never use
when machine is on an incline. Note: Brakes will lock if Park/Shunt Valve is
pressed twice.
Example System:
To Next Page
Loading...
