To Next PageTo Next PageHow to fix Sun joe SPX1000 that refuses to start?
If your Sun Joe Pressure Washer isn't starting, first, ensure it's properly plugged into a working outlet and check the power cord, resetting the GFCI if necessary. Try a different outlet. If that doesn't work, replace the fuse and switch off any other machines using the same circuit. As a last resort, try operating the unit without an extension cord, as this could be the source of the issue.
Why is my Sun joe SPX1000 pulsating?
If your Sun Joe Pressure Washer is pulsating, it could be due to several reasons. First, there might be air in the inlet hose, so allow the machine to run by holding the trigger until regular working pressure resumes. Also, ensure an adequate supply of mains water, avoiding long, thin hoses (minimum 1/2 in. diameter). Check if the nozzle is partially blocked and clean it. The water filter might also be blocked, so clean the water inlet filter. Finally, straighten out the hose to remove any kinks/blockages.
What to do if my Sun Joe Pressure Washer stops during use?
If your Sun Joe Pressure Washer suddenly stops, start by replacing the fuse and switch off other machines using the same circuit. Check that the mains voltage corresponds to the specification on the model tag. If the thermal sensor activated, leave the washer for 5 minutes to cool down. Also, the nozzle may be partially blocked, so try cleaning it.
What to do if Sun joe SPX1000 starts but no water comes out?
If your Sun Joe Pressure Washer starts but no water comes out, first, check if the pump, hoses, or accessories are frozen and wait for them to thaw. Ensure that the inlet water is connected. Also, the water inlet filter or the nozzle might be blocked, so clean them.
Why is the water pressure fluctuating on my Sun joe SPX1000?
If you're experiencing fluctuating pressure with your Sun Joe Pressure Washer, it could be due to several reasons. First, check that all hoses and connections are airtight, as the pump might be sucking air. Another cause might be dirty, worn out, or stuck valves. In this case, clean or replace the valves/seals.
Why does the fuse blow on my Sun joe SPX1000?
If the fuse blows on your Sun Joe Pressure Washer, it may be because the fuse is too small. Install a fuse with a higher amp rating than the amp consumption of the machine. Also, try the unit without an extension cord.
General safety precautions and warnings for operating the pressure washer.
The electric supply needs a residual current device or GFCI to interrupt leakage current.
Protects the motor against overloading and restarts after cooling.
Appliance uses two insulation systems instead of grounding for safety.
This high-pressure electric power washer is intended for residential use only.
Details safe operating environments and limitations for the pressure washer.
Explanation of various safety symbols used in the manual and on the product.
Identifies and illustrates the various controls and parts of the pressure washer.
Provides specifications such as voltage, power, pressure, and dimensions.
Lists all items included in the product packaging.
Step-by-step instructions for assembling the pressure washer and its components.
Instructions for connecting the pressure washer to electrical supply and water source.
Procedure for safely starting the pressure washer, including water flow and switch operation.
Guidance on using the detergent spray bottle attachment for cleaning.
How to adjust the nozzle for different pressure levels and spray patterns.
Steps to safely turn off the pressure washer and disconnect it from power and water.
Steps to take when pausing operation for five minutes or more.
Instructions for storing the pressure washer to prevent damage, especially from freezing.
Steps to minimize damage when storing the washer in freezing temperatures.
Procedure for cleaning the water inlet filter for optimal performance.
How to clean the nozzle using the provided needle clean-out tool.
Provides a circuit diagram for the pressure washer for reference.
Information on proper disposal and recycling of electrical appliances.
Contact information for service or maintenance assistance.
Instructions on where to find and record model and serial numbers.
Common causes and solutions for when the machine will not start.
Troubleshooting steps for inconsistent water pressure.
Possible causes and solutions for the machine stopping during operation.
Troubleshooting for issues related to the fuse blowing.
Causes and solutions for a pulsating or uneven operation.
Diagnosing and resolving issues where the machine cycles on and off unexpectedly.
Troubleshooting steps when no water is dispensed.
Lists and describes optional accessories for the pressure washer.
Important note regarding accessory compatibility and ordering.
Details the product warranty terms, duration, and coverage.
Instructions on how to get replacement parts or products.
Information on how to reach Snow Joe® + Sun Joe® for help and support.
General| Max Pressure | 1450 PSI |
|---|---|
| Flow Rate | 1.45 GPM |
| Power Type | Electric |
| Hose Length | 20 feet |
| Spray Gun | Included |
| Nozzles | Quick-Connect |
| Power Cord Length | 35 feet |
| Warranty | 2 years |
